Thingsform IoT
IoT use case
Water metering
Water use analysis & fraud detection
Flow
31L/min
045 L/min
Volume
211m³
12340 m³
Pressure
3.6bar
2.14.8 bar
Leak index
0.11
0.001.00
14devices
13online
5sites
1 device offline: supervision flags it rather than hiding it.
How it is wired
Sensors report to a gateway, which forwards to Thingsform over MQTT. What sets the platform apart is the lower line: the command goes back to the equipment.
- On site
- 14 devices · 5 sites
- Link
- MQTT · HTTP · Modbus
- Tracked readings
- Flow · Volume · Pressure · Leak index
What the platform does with these readings
The dashboard is only the visible part: each metric can carry a threshold, drift detection and a command in return.
Flow
0–45 L/min- Threshold outside the 0–45 L/min range
- Slow drift, spotted before the threshold is crossed
- Command sent back to the device over MQTT or Modbus
Volume
12–340 m³- Threshold outside the 12–340 m³ range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Pressure
2.1–4.8 bar- Threshold outside the 2.1–4.8 bar range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Leak index
0.00–1.00- Threshold outside the 0.00–1.00 range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Start with the Water metering dashboard
It ships configured. Connect your sensors over MQTT, HTTP or Modbus, and your values take the place of these.