Thingsform IoT
IoT use case
SCADA
Control industrial processes in real time
Line speed
137u/min
40180 u/min
Pressure
4.4bar
1.26.5 bar
Motor load
63%
2595 %
Quality
93%
92100 %
42devices
40online
2sites
2 devices offline: supervision flags it rather than hiding it.
How it is wired
Sensors report to a gateway, which forwards to Thingsform over MQTT. What sets the platform apart is the lower line: the command goes back to the equipment.
- On site
- 42 devices · 2 sites
- Link
- MQTT · HTTP · Modbus
- Tracked readings
- Line speed · Pressure · Motor load · Quality
What the platform does with these readings
The dashboard is only the visible part: each metric can carry a threshold, drift detection and a command in return.
Line speed
40–180 u/min- Threshold outside the 40–180 u/min range
- Slow drift, spotted before the threshold is crossed
- Command sent back to the device over MQTT or Modbus
Pressure
1.2–6.5 bar- Threshold outside the 1.2–6.5 bar range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Motor load
25–95 %- Threshold outside the 25–95 % range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Quality
92–100 %- Threshold outside the 92–100 % range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Start with the SCADA dashboard
It ships configured. Connect your sensors over MQTT, HTTP or Modbus, and your values take the place of these.