Thingsform IoT
IoT use case
Perimeter security
Site perimeter & intrusion monitoring
Intrusions/h
6
08
Forced doors
2
04
Cameras OK
89%
75100 %
Response time
4min
225 min
34devices
32online
2sites
2 devices offline: supervision flags it rather than hiding it.
How it is wired
Sensors report to a gateway, which forwards to Thingsform over MQTT. What sets the platform apart is the lower line: the command goes back to the equipment.
- On site
- 34 devices · 2 sites
- Link
- MQTT · HTTP · Modbus
- Tracked readings
- Intrusions/h · Forced doors · Cameras OK · Response time
What the platform does with these readings
The dashboard is only the visible part: each metric can carry a threshold, drift detection and a command in return.
Intrusions/h
0–8- Threshold outside the 0–8 range
- Slow drift, spotted before the threshold is crossed
- Command sent back to the device over MQTT or Modbus
Forced doors
0–4- Threshold outside the 0–4 range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Cameras OK
75–100 %- Threshold outside the 75–100 % range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Response time
2–25 min- Threshold outside the 2–25 min range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Start with the Perimeter security dashboard
It ships configured. Connect your sensors over MQTT, HTTP or Modbus, and your values take the place of these.