Thingsform IoT
IoT use case
Oil & gas drilling
Control drilling operations
Depth
3 289m
1 2004 200 m
Bit RPM
133
60180
Mud pressure
212bar
80320 bar
Vibration
1.0mm/s
0.28.0 mm/s
14devices
13online
1sites
1 device offline: supervision flags it rather than hiding it.
How it is wired
Sensors report to a gateway, which forwards to Thingsform over MQTT. What sets the platform apart is the lower line: the command goes back to the equipment.
- On site
- 14 devices · 1 sites
- Link
- MQTT · HTTP · Modbus
- Tracked readings
- Depth · Bit RPM · Mud pressure · Vibration
What the platform does with these readings
The dashboard is only the visible part: each metric can carry a threshold, drift detection and a command in return.
Depth
1 200–4 200 m- Threshold outside the 1 200–4 200 m range
- Slow drift, spotted before the threshold is crossed
- Command sent back to the device over MQTT or Modbus
Bit RPM
60–180- Threshold outside the 60–180 range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Mud pressure
80–320 bar- Threshold outside the 80–320 bar range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Vibration
0.2–8.0 mm/s- Threshold outside the 0.2–8.0 mm/s range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Start with the Oil & gas drilling dashboard
It ships configured. Connect your sensors over MQTT, HTTP or Modbus, and your values take the place of these.