Thingsform IoT
IoT use case
Elevator monitoring
Lift operations & maintenance
Trips/d
1 986
1202 800
Door cycles
7 472
50012 000
Motor temp
57°C
3575 °C
Active faults
1
06
24devices
23online
3sites
1 device offline: supervision flags it rather than hiding it.
How it is wired
Sensors report to a gateway, which forwards to Thingsform over MQTT. What sets the platform apart is the lower line: the command goes back to the equipment.
- On site
- 24 devices · 3 sites
- Link
- MQTT · HTTP · Modbus
- Tracked readings
- Trips/d · Door cycles · Motor temp · Active faults
What the platform does with these readings
The dashboard is only the visible part: each metric can carry a threshold, drift detection and a command in return.
Trips/d
120–2 800- Threshold outside the 120–2 800 range
- Slow drift, spotted before the threshold is crossed
- Command sent back to the device over MQTT or Modbus
Door cycles
500–12 000- Threshold outside the 500–12 000 range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Motor temp
35–75 °C- Threshold outside the 35–75 °C range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Active faults
0–6- Threshold outside the 0–6 range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Start with the Elevator monitoring dashboard
It ships configured. Connect your sensors over MQTT, HTTP or Modbus, and your values take the place of these.