Thingsform IoT
IoT use case
Construction site
Dust, noise & safety monitoring
PM10
179µg/m³
15250 µg/m³
Noise
79dB
5595 dB
Wind
9.9m/s
0.018.0 m/s
Zone presence
5
045
12devices
11online
1sites
1 device offline: supervision flags it rather than hiding it.
How it is wired
Sensors report to a gateway, which forwards to Thingsform over MQTT. What sets the platform apart is the lower line: the command goes back to the equipment.
- On site
- 12 devices · 1 sites
- Link
- MQTT · HTTP · Modbus
- Tracked readings
- PM10 · Noise · Wind · Zone presence
What the platform does with these readings
The dashboard is only the visible part: each metric can carry a threshold, drift detection and a command in return.
PM10
15–250 µg/m³- Threshold outside the 15–250 µg/m³ range
- Slow drift, spotted before the threshold is crossed
- Command sent back to the device over MQTT or Modbus
Noise
55–95 dB- Threshold outside the 55–95 dB range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Wind
0.0–18.0 m/s- Threshold outside the 0.0–18.0 m/s range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Zone presence
0–45- Threshold outside the 0–45 range
- Slow drift, spotted before the threshold is crossed
- Correlation with the site's other readings
Start with the Construction site dashboard
It ships configured. Connect your sensors over MQTT, HTTP or Modbus, and your values take the place of these.